Creo schematics central catalog loading in Windchill

We are using Schematics 7.0 and Windchill 12.0.2.2. To my knowledge what you are asking is not possible unless PTC has added some way to set Windchill as the catalog location. In 7.0 it is not possible.

That has been a request for quite a while.  
Time to plug the Routed Systems TC.  https://www.ptcuser.org/Technical-Committees/About-Technical-Committees
Things like this get discussed with some very knowledgeable people and even with Alex (product manager) to discuss solutions and new features.
Routed Systems is very open.  Anyone using Schematics or doing harness routing is encouraged to join.

We have a couple remote sites.  One was set up with a copy of the catalog.  Editing of the catalog was by a couple selected people at the main office, so the transfer only needed to be one way.

A site with only a couple people and very poor connection was set up to use remote log in to servers at the main office.  It improved the general operation of Schematics for them along with better access to the catalog.

Hi,  ptc-3298469

I am checking on some community posts.  Did you gather any insight to resolve your issue?  This may also help other community members with a similar issue.

URL:  Creo schematics central catalog loading in Windchi... - PTC Community

In the event that this response did not answer your question, please post your current status so that we can continue to support.

Thanks for using the PTC Community!

Regards,

Jaime Lee

Senior Online Community Manager

I too am looking for an answer to this question.

Why would PTC create a product that were not able to point to our Harness Schematic templates that are stored in Windchill and be able to use those from within Schematic program when selecting File > New > From Template?

Don A