PTC University LEARN Questions

Reply to ask for help or share what you have learned.

test

Reply to ask for help or share what you have learned. 

Hello- my question is with dimensioning When adding a model driven dimension sometimes the leader lines touch the part.Is there a quick way to clean these up instead of dragging the drag button over? Or is there a setting to have a certain space be the standard on the drawings? Please advise. Thank You,George Dominguezgeorge.dominguez@roberthsaw.com

Reply to ask for help or share what you have learned. 

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.

Exercise 6 - Build Display Data - the ReflowOvenMonitor is missing in the project.  The directions are to select Mashup "ReflowOvenMonitor" which does not exist in Mashups Browse list.  There is not direction on how to create the mashup.

Reply to this post to ask for help or to share what you have learned in this course.

Reply to ask for help or share what you have learned.

this is pretty frustrating as the training is not explaining. To sketch the "section as shown"- then it magically flips to the inside view.. no explanation. How do you rotate or flip like that? Is there a "hot key"?   

tutorial states simply to click the PTC icon and the learning connector will open in the drawing- it does not do that for me. Probably new user error but limiting and frustrating just the same

Reply to this post to ask for help or to share what you have learned in this course.

While Windchill starts, it can take 3-7 minutes to get beyond the Error 503 - Service Unavailable message in the browser, but it also can take up to 10 minutes.  We recommend closing the web browser and allowing the process to complete. (This wait time is usually a good time to read through the first pages of the class guidebook.) Infrequently, Windchill services will fail to start. It may continuously loop around the command prompt window. Do not select/highlight anything in the window to allow the process to continue. If it seems to be taking a long time, here are a few troubleshooting options: Option A: Restart your virtual machine sessionNote: This option will cause you to lose any work in progress.In the virtual machine toolbar, go to Profile > End Session.Relaunch the virtual machine using the same instructions as before. Option B: Restart Windchill From the virtual machine desktop, launch the Windchill Shell.At the prompt, type windchill stop.Press En

Reply to ask for help or share what you have learned.

During the “Creo: Practice Routing Wires and Cables” self-guide training, I launched the virtual machine and checked the folder path indicated in the student guide. However, only the exam folder was visible as attached pdf. Could you please confirm if this is expected or if there might be an issue?

Reply to ask for help or share what you have learned.

Reply to ask for help or share what you have learned.