Skip to main content
M
MH_107842416-Contributor
6-Contributor
February 15, 2024
Solved

Section View in Inset in Creo Illustrate

  • February 15, 2024
  • 1 reply
  • 1217 views

In a Creo Illustrate Figure, is it possible to have a section view only displayed in the inset? I do not want the section view on the main parent model in the figure view, only the section view.

    Best answer by agarland

    This isn't currently possible, as the inset is essentially just another camera looking at the main view.

    So you will always see the same content in the inset as the main view.

     

    This could be a good candidate for an Idea.

     

     

    1 reply

    A
    agarland16-PearlAnswer
    16-Pearl
    February 16, 2024

    This isn't currently possible, as the inset is essentially just another camera looking at the main view.

    So you will always see the same content in the inset as the main view.

     

    This could be a good candidate for an Idea.

     

     

      V
      Vitor_Abreu5-Regular Member
      5-Regular Member
      March 18, 2025

      Interesting that this is the first image we see when Creo illustrate opens, the helicopter in the background not only shows a section with the panel but also an exploded view of an inside component. Is this already implemented/an open Idea?

      Vitor_Abreu_0-1742302090678.png

      Terms & ConditionsCookie settingsAccessibility statement