cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Adding dimension while drawing

ClemensNader
6-Contributor

Adding dimension while drawing

Is it possible to type the dimension f.e. on a circle while im drawing it?

Because in Creo 1.0 it was possible when i clicked on the symbol and set the dimension to e.g. "60" it changed it and i could place it on the center for example.

1 ACCEPTED SOLUTION

Accepted Solutions

@ClemensNader 

When sketching circle weak dimension will appear after placing circle which can modify at any point in time and it was same in previous versions as well. But when sketching Circle in drawing, it will allow to define the radius when creating circle. 

View solution in original post

1 REPLY 1

@ClemensNader 

When sketching circle weak dimension will appear after placing circle which can modify at any point in time and it was same in previous versions as well. But when sketching Circle in drawing, it will allow to define the radius when creating circle. 

Top Tags