Adding drawing dimensions causes model to update?
I have just performed an experiment to find out why I have been losing dimensions on an assembly drawing. I selected a simple drawing, and did a few things to the drawing only, then saved it. Long story short, when adding a dimension to the drawing, and then saving the drawing, the model is updated. (This answered one question I had about when working on drawings, sometimes the model is updated, and sometimes not, even though I haven't done anything to the model.) When I cleared everything out of session and reopened the drawing, the dimension, of course, is still there. Clear everything out of session again, and this time delete the latest version of the model, because I haven't done anything to the model, open the drawing dack up, and the dimension is gone. By referencing the model, am I "revising" it? Why doesn't that dimension come up in purple, instead of just disappearing? This seems like it could become a problem, even though I've never noticed it, or come accross it before.
Has anyone else noticed this, and has it caused any problems as far as part revisions?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.