BOM table Q
May 21, 2015
09:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
May 21, 2015
09:05 AM
BOM table Q
Hi PTCusers,
I have a BOM table in my drawing for an assembly inherited from one European company.
There part numbers are 6 digits and ours are 10, so my BOM table shows only 6 digits PN.
I wonder, how can I change the way that our PN will be seen in full.
Thanks,
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Solved! Go to Solution.
Labels:
- Labels:
-
Assembly Design
ACCEPTED SOLUTION
Accepted Solutions
May 21, 2015
09:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
May 21, 2015
09:36 AM
in the table tab
select repeat region icon > relations then select your BOM table
4 REPLIES 4
May 21, 2015
09:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
May 21, 2015
09:26 AM
verify there are no BOM relations that are truncating part number lengths
May 21, 2015
09:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
May 21, 2015
09:28 AM
Thanks for your reply.
Can you tell me how verify that?
May 21, 2015
09:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
May 21, 2015
09:36 AM
in the table tab
select repeat region icon > relations then select your BOM table
May 21, 2015
09:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
May 21, 2015
09:39 AM
Ron, you got it.
Thanks a lot
