Skip to main content
F
FE_97829041-Visitor
1-Visitor
March 11, 2025
Question

Cable creating loops when routing. WHY????

  • March 11, 2025
  • 2 replies
  • 817 views

Creo is creating these loops when I route the cable, but they are not shown in the network routing. Yes, the network is continuous. The cable assembly is 4 separate connectors but the wires from one go to different connectors so they need to be on the same network. I'm not sure why this is happening. I am not recieving any network errors.

2 replies

M
MikeBennett16-Pearl
16-Pearl
March 12, 2025

Hi @FE_9782904 ,

 

I would recommend checking the spool's minimum radius dimension (min_ben_radius) and compare that to the radius of the network in the areas of the loops.  If the network radius has a tighter radius than what is defined as minimum in the spool,  the loop is created to prevent violating that minimum radius.

 

Cabling > Spools > Edit > Select the spool(s) > Ok then set the MIN_BEND_RADIUS

 

Mike

    A
    anursinghCommunity Manager
    Community Moderator
    April 20, 2025

    Hi @FE_9782904,

     

    I wanted to see if you got the help you needed.

    If so, please mark the appropriate reply as the Accepted Solution. It will help other members who may have the same question.
    Of course, if you have more to share on your issue, please pursue the conversation. 

     

    Thanks,
    Anurag 

    Terms & ConditionsCookie settingsAccessibility statement