Creo Schematics 3 compatible with Parametric 7 if we use Teamcenter PLM?

Forum|Forum|5 years ago
February 18, 2021
1 reply
2664 views

RSD Users!

The below matrix says that, CS 4.0 is interoperable with Creo 7 parametric. What it means if we use different PLM (Teamcenter) other than Windchill? How this will impact us?

- We are using Creo Schematics 3, Creo 4 Parametric with Teamcenter PLM Planning to upgrade Creo 7.

- Parametric Any impact on Creo Schematics 3? Do we necessarily need to migrate to CS 4 or CS 7?

Thanks,

Ramesh

Routed Syst. Design

Best answer by Gaby_K

Hi Ramesh,

Creo Schematics has nothing to do with Teamcenter (this is for any version of Creo Schematics) - so if you used to work with Windchill, and you are transfer to Teamcenter -> you will loss the ability to check-in/check-out designs to your PLM system from Creo Schematics UI , including generation of secondary content during check-in.

Creo Schematics 4.0 works fine with Creo 7.0 , take into account Creo Schematics 7.0.0.0 was released - you should consider to upgrade .

if you comparing to CS3 there is new functionality and lot of SPRs were resolved....

Regards,

Gaby

G

Gaby_K

Answer

12-Amethyst

Hi Ramesh,

Creo Schematics has nothing to do with Teamcenter (this is for any version of Creo Schematics) - so if you used to work with Windchill, and you are transfer to Teamcenter -> you will loss the ability to check-in/check-out designs to your PLM system from Creo Schematics UI , including generation of secondary content during check-in.

Creo Schematics 4.0 works fine with Creo 7.0 , take into account Creo Schematics 7.0.0.0 was released - you should consider to upgrade .

if you comparing to CS3 there is new functionality and lot of SPRs were resolved....

Regards,

Gaby

R

Ramesh_Mani

Author

7-Bedrock

Thanks much Gaby, it really helps!

Sign up

Please use your PTC eSupport account.

Welcome to the PTC Community

Please use your PTC eSupport account.

Scanning file for viruses.

This file cannot be downloaded