EXTERNAL: show some hidden lines in drawing

[mathew.palazola]

Yes... you are correct... some other users pointed me to this as well.

The only problem I STILL have is that this works for the "true" edges of the tap-drill, but does NOT work
for the "silhouette" edges for the thread major diameter, which is just a surface, and major diameter bottom/end.

It's not a layer issue I have, I unblanked all layers... still no luck.

Thanks to everyone for their input and help

Matt

[DonSenchuk]

When I've run into this in the past I would just make a either a breakout section on the main view or a section view of the area while leaving the main view set to 'no hidden'.

In Reply to Mathew Palazola:

Yes... you are correct... some other users pointed me to this as well.

The only problem I STILL have is that this works for the "true" edges of the tap-drill, but does NOT work
for the "silhouette" edges for the thread major diameter, which is just a surface, and major diameter bottom/end.

It's not a layer issue I have, I unblanked all layers... still no luck.

Thanks to everyone for their input and help

Matt