FDM - Summary
Jul 25, 2013
08:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Jul 25, 2013
08:09 AM
FDM - Summary
Wow!
I couldn't believe the wide range of offers and prices for these parts.
The cheapest commercial rate I got had been $160 for the three + shipping.
I had several offers from the exploder ranging from $50 to $350
In the end, a friend of mine in San Antonio had room on his Stratasys and
ran them last night - guess I'll take him to lunch today
Thanks for all your help and the input - a lot of valuable info for the
future.
Anthony R. Benitez
Senior Mechanical Designer - Supervisor
Applied Research Laboratories - The University of Texas at Austin
-
This email and/or attachments contains export controlled material under
applicable laws of the United States. This material should only be handled
by US persons (a person that is a permanent legal resident of the The United
States or a protected individual) and should not be shared with any non-US
person.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
I couldn't believe the wide range of offers and prices for these parts.
The cheapest commercial rate I got had been $160 for the three + shipping.
I had several offers from the exploder ranging from $50 to $350
In the end, a friend of mine in San Antonio had room on his Stratasys and
ran them last night - guess I'll take him to lunch today
Thanks for all your help and the input - a lot of valuable info for the
future.
Anthony R. Benitez
Senior Mechanical Designer - Supervisor
Applied Research Laboratories - The University of Texas at Austin
-
This email and/or attachments contains export controlled material under
applicable laws of the United States. This material should only be handled
by US persons (a person that is a permanent legal resident of the The United
States or a protected individual) and should not be shared with any non-US
person.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
2D Drawing
0 REPLIES 0
