Filters in Repeat Region

Forum|Forum|11 years ago
December 6, 2014
2 replies
3520 views

Hi,

I have a repeat region with some parameters based on a part, and I want to add a filter based on a parameter of that part, my Question is: Can I filter my repeat region with a parameter? In case that if I change the value of the parameter when I regenerate the part, the filter could automatically change and show a different result in my table.

I hope you can help me with that.

Thanks

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

General

T

TomD.inPDX

17-Peridot

I am not good at repeat regions but I wanted to welcome you to the forum.

I am sure you can add a logical parameter to a repeat region to have an entry evaluated, I just don't know how.

D

dschenken

1-Visitor

Have a look at this thread: http://communities.ptc.com/thread/35930

You could use the parameter to eliminate rows from a table where a value matches the value of a parameter using a filter.

I think you cannot use a parameter value as a way to select other parameters in the table. That is, if you have a parameter "Width" and another "Depth" you cannot have a parameter "Select" that can be used to define a column that switches between the other two.

Other references

http://communities.ptc.com/thread/42603

http://www.mcadcentral.com/creo-drawing/22971-repeat-regi-n-filter-via-null-parameter.

Sign up

Please use your PTC eSupport account.

Welcome to the PTC Community

Please use your PTC eSupport account.

Scanning file for viruses.

This file cannot be downloaded