Skip to main content
A
ashaikh1-Visitor
1-Visitor
September 13, 2015
Question

How to Rotate Whole Assembly??

  • September 13, 2015
  • 1 reply
  • 2101 views

AZIM-PC-2015-sep-13-007.jpg

Hello,

I want to ask How to Rotate Whole Assembly??

as shown in snap, i have assembled the parts, but unfortunately, something went wrong after that the assembly got tilt by an angle.

Please help me to set assembly as parallel to Horizontal axis


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1 reply

D
DG_8950681-Visitor
1-Visitor
September 15, 2015

Hello Azim, the open box next to the part name means the model is not fully constrained.

That allows creo to make assumptions...just like in real life, they will almost always be wrong.

I'm guessing your placement windows looks like the top snapshot...it good practice to not hit the green check-mark until the model is fully constrained. It may require up to (3) constraints.

Good Luck

Terms & ConditionsCookie settingsAccessibility statement