Skip to main content
F
FieldEng12-Amethyst
12-Amethyst
April 1, 2024
Solved

How to add mass to a point

  • April 1, 2024
  • 2 replies
  • 4102 views

I have a 3D frame model and I want to add mass to a point to locate the CG of a component.  The Help section says to use the Refine Model --> Mass function to do this, but I haven't been able to locate that function on the Ribbon, or in any of the Toolbars.  Where is this located?

 

https://support.ptc.com/help/creo/creo_pma/r10.0/usascii/index.html#page/simulate/simulate/add_mass_pt.html

2 replies

T
Tdaugherty16-Pearl
16-Pearl
April 1, 2024

The article you linked is referencing the Simulate application. This is used for FEA. 

 

Tdaugherty_0-1711976397213.png

 

Tdaugherty_1-1711976408400.png

 

Tdaugherty_2-1711976419591.png

 

    F
    FieldEng12-AmethystAuthor
    12-Amethyst
    April 1, 2024

    Bummer.  Unfortunately, I don't have Simulate.  I didn't realize that's where I was copying the link from.  Thanks for the quick reply.

    tbraxton
    22-Sapphire II
    tbraxton22-Sapphire IIAnswer
    22-Sapphire II
    April 1, 2024

    I think this is relevant to what you are asking about.

     

    Article - CS60265 - How to assign user defined mass properties for a model, part or assembly, in Creo Parametric (ptc.com)

      F
      FieldEng12-AmethystAuthor
      12-Amethyst
      April 1, 2024

      This pointed me in the right direction.  Thanks.  I was trying to assign mass to a datum point, but apparently I can't do that.  I tried to create just a point in a sketch and assign mass to that.  I can't finish the sketch, because it's just a point.  So I created a sphere and assigned the mass to that.  Then I'll locate the masses in the assembly to give the total package the necessary weight distribution.

       

      Thanks for the help.

      R
      RPN18-Opal
      18-Opal
      April 11, 2024

      The box represent 1 kg of water.

      The size is 100x100x100 mm^3 with a density of 1g/cm^3 this equals to 1 Liter  10cmx10cm10cm = 1kg

      Now I want that the weight is 5 kg

      Alternate from  GEOMETRY to PARAMETER

      PRO_MP_ALT_DENSITY enter 5 times more 0.000005 kg/mm^3 (PTC does not change this to the assigend unit g/cm^3 🙂

       

      After Calculation (weired sh%$) the model weights now 5 kg if used in one Assembly.

      You can do the same with all the other parameters.

       

      (view in My Videos)

       

       

        Terms & ConditionsCookie settingsAccessibility statement