How to adjusting the length of elbow dimensioning lines Creo 2.0 M080

[lgrant]

In Wildfire you could highlight the dimension and adjust it using by grabbing the end of the line. In Creo I can’t figure out how to do this?

I think this is someplace in Dimension Properties.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomD.inPDX · Accepted solution]

Shift-drag

[ClintWalton]

As Antonius said, hold the Shift key while hovering over the dimension. Here is the document for this:

https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS66313&source=tssearch