Skip to main content
T
tdickson1-Visitor
1-Visitor
June 29, 2015
Question

Issues with "no hidden" showing lines that should be hidden

  • June 29, 2015
  • 2 replies
  • 4170 views

Hello,

I'm having an issue where I select the "no hidden" option in my drawing, but some components display as if they are in wire frame. Lines that should be hidden are not. The same issue can also be seen in the model when the view display is set to "no hidden."

Thanks in advance.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

    2 replies

    S
    23-Emerald III
    StephenW23-Emerald III
    23-Emerald III
    June 29, 2015

    If you have interferences in your models, Creo will sometimes show hidden lines as solid.

    T
    tdickson1-VisitorAuthor
    1-Visitor
    June 29, 2015

    Interference's between the two components in the assembly, or within the component itself?

    S
    23-Emerald III
    StephenW23-Emerald III
    23-Emerald III
    June 29, 2015

    2 components in an assembly. I assume it's like this post...Re: Edges disappear in drawing only your edges are showing instead of disappearing.

    K
    KenFarley21-Topaz II
    21-Topaz II
    June 29, 2015

    Another possibility is that you are using models obtained from a supplier that are not solid models. If a STEP file is read in and has non-manifold surfaces, it will just stay a surface model, and thus not behave properly in hidden line and no hidden line views.

      Terms & ConditionsCookie settingsAccessibility statement