Skip to main content
L
LK_100807387-Bedrock
7-Bedrock
October 5, 2022
Question

ModelCHECK not working on harness MFG

  • October 5, 2022
  • 2 replies
  • 1798 views

I have been trying to run MODELcheck in created MFG assembly (nailboard), but the button is grayed out and I'm not possible to use it. I tried to edit my config_init, but I'm not sure what exactly should I look for.

2 replies

V
24-Ruby III
VladimirN24-Ruby III
24-Ruby III
October 5, 2022

 Hi,

 

1. What version of the program are you using?
2. Please show a screenshot of your issue.

L
LK_100807387-BedrockAuthor
7-Bedrock
October 6, 2022

Hello,

 

I am using Creo 7.0.

This is the issue. without modelcheck I cannot checkin the assembly. So I guess there has to be a way how to enable it.

LK_10080738_0-1665036349618.png

 

M
MartinHanak24-Ruby III
24-Ruby III
October 5, 2022

Hi,

I am not sure whether MODELcheck can check MFG assembly. I guess that that in checks parts, assemblies and drawings, only.

L
LK_100807387-BedrockAuthor
7-Bedrock
October 6, 2022

Hello,

 

Thanks for your reply. Without modelcheck process, I'm unable to CheckIn the assembly to commonspace. If I try to CheckIn the assembly without modelcheck, conflict managment window will pop up with error.

M
MartinHanak24-Ruby III
24-Ruby III
October 6, 2022
@LK_10080738 wrote:

Hello,

 

Thanks for your reply. Without modelcheck process, I'm unable to CheckIn the assembly to commonspace. If I try to CheckIn the assembly without modelcheck, conflict managment window will pop up with error.

Hi,

if you have active Support at PTC then I suggest you to contact PTC Support.

Terms & ConditionsCookie settingsAccessibility statement