Repeat Regions for Wire Harness

Forum|Forum|5 years ago
July 19, 2020
1 reply
1028 views

I created a repeat region for a wire harness, details include: From/To Connectors and Pins, Wire specs such as color gauge, length. All data are populated except for the From/To Pin names (harn.run.cond.from.pin.name). How do I resolve this? Thank you!

2D Drawing

O

oull

16-Pearl

Hi,

Normally the entry port for wire must be linked to a pin then &harn.run.cond.from.pin.name will fil in the from/to pin name in the repeat region Table As described in Article - CS133154

https://www.ptc.com/en/support/article/CS133154

Please refer to Creo Help about how To Assign an Entry Port to a Pin Number :

http://support.ptc.com/help//creo/creo_pma/usascii/index.html#page/electrical_design/cable/About_Entry_Ports.html

http://support.ptc.com/help//creo/creo_pma/r8.0/usascii/index.html#page/electrical_design/cable/About_Entry_Ports.html

and to this video Demo at:

https://support.ptc.com/images/cs/articles/2018/09/1536220508kdQi/demo.mp4

Regards