Restricted Parameters table for SMT_THICKNESS

[BenLoosli]

I would like to see the restricted parameters file allow entries for SMT_THICKNESS so default material thickness values can be grabbed easily when defining the sheetmetal thickness.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[TomD.inPDX]

Sheet Metal Enhancement - Add sheet gauge material option

[Tmetcalf]

Hi Antonius -

Looks like your response cannot be viewed by the community - is everything good on your end?

Would you please repost?

Thank you,

Toby

[TomD.inPDX]

I have no idea as to what the link was. 1st time that appened in the forum that I know of.

[Tmetcalf]

Hmmm - did you try to post a link?

Sometimes that puts the post into a moderation queue.

Thank you,

Toby

[TomD.inPDX]

Probably an ideas link. I simply don't recall my reply.