Sheetmetal reset settings

[Dom_CHENTRE]

Hi, I'm working for many years with a supplier.
So, I was  using its templates.
A lot of relations, parameters...
Now I would like to reset all of this this and use standard PTC standards.
Is it possible ?
How to know if everything is reseted .
Thanks

[BenLoosli]

Create a new template file.

Uncheck the Use default template box and use an empty template.

You will have nothing, not even a coordinate system or planes.

[Patriot_1776]

'Sup Ben!  What's with the "trophy" symbol?  Do you get that when you're to a certain limit/gemstone, or is it because of being on a committee or something?

[BenLoosli]

Community Champions get the trophy.

I guess I come off as knowing something about Creo and Windchill!

Maybe this movie quote applies: "Indo has forgotten more about dispensing pain than you or I will ever know."

[Dale_Rosema]

https://community.ptc.com/t5/Welcome-How-To-s/2022-PTC-Community-Champions-Are-Here/m-p/747512#M639

[Patriot_1776]

Ah, missed that, thanks Dale!  I'd also nominate a couple guys who have contributed a lot, but simply haven't been on here in a while:  Tom Dirriwachter and Brian Martin.  Dunno whatever happened to them.

[Dom_CHENTRE]

Thanks Ben,
However, I have some old sheetmetal parts, with qpecifics relations and bending table.
Is it possible to reset all of this ?
Using skeletons, geometric copies...
Not simple to desing them again.