Skip to main content
W
Wolfman1-Visitor
1-Visitor
November 22, 2017
Question

Short edges with threads

  • November 22, 2017
  • 1 reply
  • 1416 views

When modeling threads with the helical sweep, I get "short edge errors" when I run Model Check Regenerate. Is there a way to fix this? Thanks.

1 reply

M
Mahesh_Sharma22-Sapphire I
22-Sapphire I
November 23, 2017

Short edge error in ModelCHECK report is an indication that part has edges shorter then specified limit..

 

You can disable that check by changing the E to N in respective check file. OR change the value of possible short edge in respective constant file. 

    Terms & ConditionsCookie settingsAccessibility statement