Skip to main content
S
sps-31-Visitor
1-Visitor
August 8, 2016
Question

auxillary view

  • August 8, 2016
  • 1 reply
  • 8480 views

Hi

 

Hi friends if anybody know how to rotate auxiliary view in creo means please help me out

1 reply

S
23-Emerald III
StephenW23-Emerald III
23-Emerald III
August 8, 2016

Right click on the view, select properties. Change AUXILLARY in the type drop down to GENERAL, then APPLY. You will get additional options then. Use GEOMETRY REFERENCES or ANGLES to rotate the view as desired.

    A
    Ajithkumar1-Visitor
    1-Visitor
    August 23, 2018

    Is there any standard angle for auxiliary view? If it's there any standard values please reply.

    S
    23-Emerald III
    StephenW23-Emerald III
    23-Emerald III
    August 23, 2018

    An Auxillary view is an orthographic projection that is taken from ANY angle that is required to accurately represent the geometry.

    In the image below, the auxillary view is at the angle of the surface that the hole is one so the hole is shown "true".

    aux-view.jpg

      Terms & ConditionsCookie settingsAccessibility statement