Hi alls,
I have some parts that are made of facet features.
I make some cross section and it's fine.
Then I can make curves out of them.
Model / datum / curve / curve from cross section.
So, I get curves but they have some kind of datum point on them.
They are always display, when datum point are display or not.
They are on the same layer than curve.
Is there any configuration option to hide them ?
Is there any explanation on this ?
Thanks,
GB
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
