Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hello, everyone,
how do I manage the dimensions of the GAS threads?
The metric puts the prefix M while for GAS puts the symbol diameter and is not good.
thanks
Solved! Go to Solution.
@IF wrote:
ok...for displaing G prefix in gas thread?
Hi,
I suggest you to ask PTC Support. I guess that M prefix is hardcoded for ISO standards and diameter symbol is hardcoded for other standards 😞
Hi,
metric hole diameter displays prefix M, because ISO.hol file contains following line
THREAD_SERIES ISO
See also
ok...for displaing G prefix in gas thread?
@IF wrote:
ok...for displaing G prefix in gas thread?
Hi,
I suggest you to ask PTC Support. I guess that M prefix is hardcoded for ISO standards and diameter symbol is hardcoded for other standards 😞
ok thank you so much!