Skip to main content
S
schopra-21-Visitor
1-Visitor
March 30, 2014
Question

having problem regenerating the tubing in EFX extension

  • March 30, 2014
  • 3 replies
  • 1672 views

i am facing certaing problems in regenerating the chassis tubings in EFX extension.i want to do a analysis of chassis this wont let me do it.

is there a possible solution to this problem.

the assembly file is attached


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

3 replies

T
TomD.inPDX17-Peridot
17-Peridot
March 30, 2014

Hello Sagar. I am not ignoring you but I have little experience with tube frame analysis. I also do not have the EFX extension available.

However, if you have an active maintenance contract, by all means file a support case.

T
TomD.inPDX17-Peridot
17-Peridot
March 30, 2014

...and be aware that people with full version Creo cannot open academic versions of files. It appears you only have the assembly in the zip file. Are there not support PRT files needed?

S
schopra-21-VisitorAuthor
1-Visitor
March 30, 2014

yaa i am using acedamic version on creo parametric 2.0 so can i ask ptc support for help

T
TomD.inPDX17-Peridot
17-Peridot
March 30, 2014

yes, read this post for a link to academic support page:

Student Version installation problems

S
schopra-21-VisitorAuthor
1-Visitor
March 30, 2014

yaa i have posted the doubt in support forum thanks for the advice hope they will reply

Terms & ConditionsCookie settingsAccessibility statement