1-Visitor

Solved

how to heal imported model by IDD

Forum|Forum|13 years ago
October 11, 2012
1 reply
9309 views

Dear friends,

I am struggele two days to repair a imported model to solidify it, up to end I am surrender by last one green line. My firend, can you please show me how to del or modifly the imported model which can be solidify to get model mass, thank you very much.

My Proe is WF4.0

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

1_nhl--flk-prt-7.zip

Data Exchange

Best answer by ptc-4763147

What´s the problem? It is able to repair it and solidify is posible.

I thing i done it this way:

delete surface that are unuseful

detach all broken surface and merge them together

when it is´t able to merge it i use collaps two groups of surface

in four/five step finished

i can write it better way but i don`t know where is main problem

bye

Answer

1-Visitor

What´s the problem? It is able to repair it and solidify is posible.

I thing i done it this way:

delete surface that are unuseful

detach all broken surface and merge them together

when it is´t able to merge it i use collaps two groups of surface

in four/five step finished

i can write it better way but i don`t know where is main problem

bye

1_nhl--flk-stp.zip

Author

1-Visitor

thank you John, you did it.

my problem is I do not know how to handle the green line. can you make a few sceen shot or vedio show me how to do it, thank you very much!

best regards, Hongjie

15-Moonstone

There is a pdf tutorial in the reference documents under ptc support.
It tells you what action to take in which situation...