Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Translate the entire conversation x

Anyone know when Creo View ECAD adapters will support Cadence 24.1?

avillanueva
22-Sapphire III

Anyone know when Creo View ECAD adapters will support Cadence 24.1?

I know this is a future question but perhaps a PTC PLM can chime in. I see that Cadence released version 24.1 last year. I was curious if Creo View Adapters 12 will support this version. The 11.1 version only supports up to 23.1. 

ACCEPTED SOLUTION

Accepted Solutions
kajohnson
14-Alexandrite
(To:avillanueva)

You will see support for Cadence 24.1 in the upcoming Creo View Adapter 12.0 release in June. This will be included in the next update of the Creo View Future Support Matrix ~March/April –

View solution in original post

1 REPLY 1
kajohnson
14-Alexandrite
(To:avillanueva)

You will see support for Cadence 24.1 in the upcoming Creo View Adapter 12.0 release in June. This will be included in the next update of the Creo View Future Support Matrix ~March/April –

Announcements

Top Tags