Creo Schematics: Run the two applications (Full and Lite) next to each other

[NC_4023452]

Can I easily switch between the Lite and the Full versions? The end users want to be able to use both for a while

[VladimirN]

Some additional information:

• "Creo Schematics Lite vs Full": https://community.ptc.com/t5/3D-Part-Assembly-Design/Creo-Schematics-Lite-vs-Full/td-p/288920
• "Functionality difference between Lite and Full version of Creo Schematics": https://www.ptc.com/en/support/article/CS38879
• "Limitations of Creo Schematics Lite": https://www.ptc.com/en/support/article/CS38879https://support.ptc.com/help/creo_schematics/r9.0/en/index.html#page/schematics/creo_schematics/Limitations_of_Creo_Schematics_Lite.html

[NC_4023452]

I know the different between the Full and the Lite but I want to run them together on one PC.

So that I can choose if I start the Lite or the Full.

[NC_4023452 · Accepted solution]

The problem is solved. It's a setting in the install procedure.