Skip to main content
F
Florian941-Visitor
1-Visitor
March 23, 2018
Question

Hatching on Creo View

  • March 23, 2018
  • 2 replies
  • 2702 views

Hello everyone !

 

I think it could be great to enable Creo View to display hatching on a section. This is something widely used on the industry and really important for the Model Based Design.

 

Is there any enhancement on this subject ?

 

Have a nice day 🙂

    2 replies

    D
    dschenken1-Visitor
    1-Visitor
    March 23, 2018

    If you are under maintenance check https://support.ptc.com/apps/solution_preview/solution/lang/presolution?lang=en&n=CS208090 I am not, so am limited to the problem description.

    F
    Florian941-VisitorAuthor
    1-Visitor
    March 26, 2018

    Thank you for your answer !

     

    At the end of the article it's explained that Cross-Hatch is exported (in .pvz) as a "Cosmetic Geometry". But Cosmetic Sketch Properties is not supported by Creo View Adapters ..

     

    So it seems there isn't any solution .. unless PTC enable Creo View to read Cometic Properties..

    V
    VeqTor1-Visitor
    1-Visitor
    June 17, 2020

    It is a severe limitation that sections can not be hatched in Creo View.

     

    This feature really should be added. 

    R
    romorrison14-Alexandrite
    14-Alexandrite
    June 17, 2020

    The idea to support this enhancement has been created here:

     

    https://community.ptc.com/t5/Addtl-Creo-Ideas-Creo-View/Hatching-on-Creo-View/idi-p/558431

     

    It would be good to up vote this if you feel it's an important enhancement.

      Terms & ConditionsCookie settingsAccessibility statement