cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Add a wizard into Creo Flow Analysis

bduncan
15-Moonstone

Add a wizard into Creo Flow Analysis

1 ACCEPTED SOLUTION

Accepted Solutions
RadovanMíček
14-Alexandrite
(To:bduncan)

7 REPLIES 7
RadovanMíček
14-Alexandrite
(To:bduncan)

Check this picture. It should be implemented in Creo 6 (maybe 6.0.1.0.)

CFD.png

Software consultant.

Thanks a lot,would you share the document?

RadovanMíček
14-Alexandrite
(To:bduncan)

This is only one slide regarding Creo Flow Analysis.
https://www.ptc.com/en/support/article?n=CS299466&language=en&posno=4&q=Creo%20Flow%20Analysis&Produ...
Software consultant.

Wizard tool is not available in Creo 6.0.1.0 yet, the plan is adding it into Creo 6.0.2.0

DavorGranic
14-Alexandrite
(To:tshen)

Don`t see it in 6.0.2.0 either.

It is possible in Creo 6.0.2.0. , but you need a special update Simerics file.

Please wait for Creo 6.0.3.0 or contact PTC support.

CFD.png

Software consultant.

Refer to technical article https://www.ptc.com/en/support/article?n=CS311282,

Flow analysis Wizard will be added into Creo 4.0 M120 and Creo 6.0.3.0

Announcements
Attention: Creo 7.0 Customers
Please consider upgrading
End of Life announcement here.

NEW Creo+ Topics:
PTC Control Center
Creo+ Portal
Real-time Collaboration