cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Auto-remember previous constraints

ccates
1-Newbie

Auto-remember previous constraints

Hello all,

 

We are trying to find the setting that basically allows the function of remembering constraints upon assembling the same component. I have seen it in the past when I assemble a bracket with 3 constraints, I then assemble the same part again and the placement has the constraints I previously used in place. Does anyone know the config setting to turn this on?

 

Thanks

 

CC


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2
TomU
23-Emerald IV
(To:ccates)

you could use the repeat function

- mark your component

- RMB Repeat

- select which assembly constraints you want to set

- Add to the selection list

When you have placed all components

- Confirm

Reinhard

Top Tags