Creo Ansys Simulations fails to complete an analysis

[NiloyGuha]

I am using Creo Parametric 8.0 8.0.0.0

Analysis fails after mesh is created and 99% of the FEA is completed of a fairly complex assembly. The same assembly has been successfully analysed in Creo Simulate.

[NiloyGuha]

The error message is attached.

[hhiller]

Opened C15883128

[hhiller]

For solution refer to article: https://www.ptc.com/appserver/cs/view/solution.jsp?n=CS344735

[NiloyGuha]

A SPR has been filed as the error has been replicated by PTC tech support. So now we need to wait for them to figure out the cause of the error.

[DaveMartin]

That link no longer works.

[NiloyGuha · Accepted solution]

Hi Dave,

The issue got resolved in Creo 9.0.1.0. There was a problem in the previous versions of Creo Ansys Simulation.

Regards,

Niloy