Creo Warning Messages - Config.pro options?

Forum|Forum|13 years ago
October 16, 2012
3 replies
6070 views

Hello all,

I tried to do some search for this, but was unable to find it on my own. Maybe someone out there has the answer. We are currently running Creo 1.0 M030. I like the software, but there are two warning messages that pop up that are a little annoying and I am wondering if there are any config.pro options that control their display. Please see the attached files.

-GAF

General

S

SM_9292819

5-Regular Member

Gregory,

This tutorial on Learning Exchange will answer you question about "warn1". There is a configuration setting that tells Creo to switch from adding materail to removing materail based on the direction of the extrude. Watch this for the full explanation:

http://learningexchange.ptc.com/tutorial/2876/smart-extrusions

Cheers

G

GregFrankland

Author

1-Visitor

Thanks for the reply, and nice tutorial!

I knew about the automatically switching from protrusion to cut. I was wondering if there is a way to turn off these warning messages that pop up. I can click on the check box that says don't show in the future, but it always comes up the next time I launch the software.

-Greg

J

jsarkar

1-Visitor

for warning 2> if u check the box of do not show future option, is that not working?