Does anyone have access to the Creo 4.0 beta

[dconnor-3]

Hi All

i am trying to access the Creo 4.0 beta through the invite i recieved but get the following

Access to this place or content is restricted. If you think this is a mistake, please contact your administrator or the person who directed you here.

cheers

Dave

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[VladimirN]

Hi,

Please contact with @Toby Metcalf

[JimBarrettSmith]

Hi David

I have invited you to the community - please confirm you have access. 

Vladimir et all

To obtain access to the community forum contact -

Best Regards, Jim

[rohit_rajan]

I did send an email but did not get any response.

[JimBarrettSmith]

Hi Rohit

I have re-invited you, please let me know if you did not receive the e-mail

Cheers, Jim

[rohit_rajan]

I have still not received the invite Jim.

[rohit_rajan]

is it possible for you to send me invite on this email id : -

[JimBarrettSmith]

Hi Please check you spam folder

thanks

Jim

[rohit_rajan]

yes i did check the spam folder its not there either,

[rohit_rajan]

yes now i have received the invite.Thank you very much.

[kfilurin]

Hi, Jim.

I also send an email to - but did not get a response.

Can you invite me? My e-mail: filyurin@areopag-spb.ru

Thanks!

[JimBarrettSmith]

Flurin and Rohit

Try this link, you have been invited so you should have access PTC Creo Sneak Peek

thanks

Jim

[kfilurin]

Thanks a lot! It works.