cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

MDO Gear Loads - "Use in Structure" (WF5, Creo 1 & 2)

Amethyst

MDO Gear Loads - "Use in Structure" (WF5, Creo 1 & 2)

Has anybody noticed that gear tooth loads are not available to pass to a Structure analysis when you select "Use in Structure" from a mechanism analysis (MDO)? I find this hard to believe that it’s been left out. Do any of you have a need for this functionality? I’d be interested to hear from anyone on this topic.

Thanks!


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
5 REPLIES 5

Re: MDO Gear Loads - "Use in Structure" (WF5, Creo 1 & 2)

PTC recognizes gear loads are not being passed from MDO to Structure and agrees it is not proper behavior. The development team is working on fixing it under a formal SPR. I beleive the target fix will be Creo 2 - does anybody need this capability in a prior version?

Cheers

Re: MDO Gear Loads - "Use in Structure" (WF5, Creo 1 & 2)

yes it is needed but is this available now in creo 2?

Re: MDO Gear Loads - "Use in Structure" (WF5, Creo 1 & 2)

I beleive the target fix will be Creo 2 - does anybody need this capability in a prior version?

Yes please in WF 5.

Re: MDO Gear Loads - "Use in Structure" (WF5, Creo 1 & 2)

Thanks

Re: MDO Gear Loads - "Use in Structure" (WF5, Creo 1 & 2)

The fix for this issue is in Creo 2.0 M040, which shipped in February 2013.

Announcements