Screw-nut modelling

Forum|Forum|11 years ago
April 4, 2015
1 reply
1000 views

Hello,

I need your help because i want to modelize a screw-nut joint on Creo 2.0. After that, i would like to simulate a rotation to control the translation of the screw.

Thanks a lot

Best regards

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.