I'm attempting a study of a Macpherson strut and struggling to figure out how to input the damping characteristics. I have the Creo Mechanism dynamics option but as far as I can tell the damping coefficient would be the same in both compression and rebound. I'm wondering if there is a better way to represent the damper. Anyone have experience with this?
Hello.
Of course. I had this struggle too. Mr.
Check it out: Solved: Change velocity of servo motor according to force ... - PTC Community
You will need to create the measure of your interest. Trying to remember something about my time of Baja SAE, I would say that you will need create a Measure of Velocity of you Damper.
Then, while creating the Force Motor, use this measure as Primary Variable.
Now you will be able to use the Velocity as Domain of your motor.
I'm not 100% sure about this path, but this is the logic. I believe you will be able to solve your problem.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
