Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
I have a square block which i want to show it moving on two vertical guide rails like a elevator. i dont know how to apply a servomotor in this case. any help in this regard.
Regards
Sammy
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
I guess you are looking for this, as shown in the video (resolution is not so good). You have chose planner connection and select the linear axis of motion while select motion axis for servo motors. chanked the attached files.
I guess you are looking for this, as shown in the video (resolution is not so good). You have chose planner connection and select the linear axis of motion while select motion axis for servo motors. chanked the attached files.
Thanks for the reply. Actually i am trying to give motion to an elevator model so is it in any case possible to show a rope between the elevator car and counter weight which actually moves over a pulley on the top.
