cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Translate the entire conversation x

Creating Skeletons

kmoen
1-Visitor
1-Visitor
‎Mar 05, 2009 12:47 PM
‎Mar 05, 2009 12:47 PM

Creating Skeletons

I have created hundreds of skeletons but never had a time where I had my create skeleton option greyed out. Any ideas????
0 Kudos
Notify Moderator
2 REPLIES 2
ptc-168913
1-Visitor
1-Visitor
(To:kmoen)
‎Mar 05, 2009 02:41 PM
‎Mar 05, 2009 02:41 PM

By default you can only create 1 skeleton in a given assembly. There is a
config.pro option to allow more than one:

multiple_skeletons_allowed yes/no (default is no)

Haven't seen what you describe otherwise.

--
Ryan


0 Kudos
Notify Moderator
kmoen
1-Visitor
1-Visitor
(To:kmoen)
‎Mar 05, 2009 06:07 PM
‎Mar 05, 2009 06:07 PM

thanks, everyone!! It seems that to do this you need Advanced Assembly Extention (AAX) module to create simple Skeletons. My admin is installing my AAX today. thanks
0 Kudos
Notify Moderator
Announcements
Business Continuity with Creo: Learn more about it here.

Top Tags