Skip to main content
P
ptc-67614051-Visitor
1-Visitor
November 20, 2014
Solved

pipe over two planes

  • November 20, 2014
  • 1 reply
  • 1752 views

i've attached a picture, the bottom pipe is on a different plane angled at 10 degrees from the plane the top pipe is on.

I am trying to either create a joint between the two or, better yet, make the two pipes one.

The problem i have is that any joint i try to put on these pipes either does absolutely nothing or creates a strange pipe which would not be able to actually be welded together.

Any help on this would be gratefully received

Best answer by ptc-6761405

figured out a way.....created 2 planes, one on each of the two pipe ends then created an axis on the intersection of these two axis. Measured angle between two planes and offset a third plane at half this angle.

Finally using the top left "replace surface" joint (create a joint to replace the selected surface) I extended each pipe end to this third plane

whew......got there in the end!!

1 reply

P
ptc-67614051-VisitorAuthorAnswer
1-Visitor
November 20, 2014

figured out a way.....created 2 planes, one on each of the two pipe ends then created an axis on the intersection of these two axis. Measured angle between two planes and offset a third plane at half this angle.

Finally using the top left "replace surface" joint (create a joint to replace the selected surface) I extended each pipe end to this third plane

whew......got there in the end!!

Terms & ConditionsCookie settingsAccessibility statement