Aspect ratio of prismatic elements (wedges & bricks)

[gfraulini]

Hi all,

although in AutoGem settings it is setted a max aspect ratio of the elements of 10, where there are bricks and wedges this rule is not observed.

You can see the image below. (Creo 2)

The question is simple: why?

Regards

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[gfraulini]

The ratio of the elements is more than 10.

There are elements too long in height in respect the base

[gfraulini]

here is the model

I've used a set of points to enable the separation.