ModuleWorks Simulation doesn´t start, Creo Parametric crashs

Forum|Forum|3 years ago
November 29, 2022
1 reply
905 views

I am using Creo Parametric Release 3.0 and DatecodeM190

ModuleWorks Simulation doesn´t start, Creo Parametric crashs

Here are the errors that I faced
Fatal Error

General

Best answer by VladimirN

Hi,

Can the following materials help you?

"The simulation is wrong in Moduleworks in Creo Parametric": https://www.ptc.com/en/support/article/CS291880
"Fatal error message": https://community.ptc.com/t5/Analysis/Fatal-error-message/td-p/269719

V

VladimirN

Answer

24-Ruby III

Hi,

Can the following materials help you?

"The simulation is wrong in Moduleworks in Creo Parametric": https://www.ptc.com/en/support/article/CS291880
"Fatal error message": https://community.ptc.com/t5/Analysis/Fatal-error-message/td-p/269719

Sign up

Please use your PTC eSupport account.

Welcome to the PTC Community

Please use your PTC eSupport account.

Scanning file for viruses.

This file cannot be downloaded