Skip to main content
M
Mickyd11-Visitor
1-Visitor
April 3, 2012
Question

plunge feedrate in creo

  • April 3, 2012
  • 1 reply
  • 1301 views

hello everyone

been using creo 1 for a few months im having trouble when trajectory milling , if i take more than one cut the plunge feedrate only works on the first cut but after the first cut it plunges at the cut feed rate which can be too quick sometimes is it possible to change this.

thanks for any help mick


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

    1 reply

    S
    SteveLucas1-Visitor
    1-Visitor
    April 3, 2012

    Dave,

    You might need to set the approach feed rate to the same as the plunge feed rate.

    I did a quick trajectory mill setting the plunge feed and and coded it out. Then

    went back in and set my plunge feed to 10 my free feed to 15 and approach feed to 6 and this is the code.

    My cutting feed was 25.

    they seem to be consistant through out the program.

    feed rates.JPG

    parameters.JPG

    Hope this helps

    Terms & ConditionsCookie settingsAccessibility statement