Hi there I need some help to simplify the program that I made in Mathcad Prime 3.1 . I am using lookup to get the required profile. But there are 2 conditions that I need to satisfy. If in condition 1 satisfied the pre selected profiles. Condition two also should pass the utilization. If condition two did not pass how this will pre select up to a higher value to satisfy both conditions. I attached the file for your reference.
I have experience that it does not work most of the time.
What you then should do is iterate inside the program for each of the input values.
So in essence:
r <- ORIGIN
if IsArray(x)
for i el ORIGIN...last(x)
Rr <- Select(xi,yi,data)
r <- r+1
return R
will give you a nested array with the results.
Assumption is that y is as long as x. If not, your program becomes more complex.
Success!
Luc
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
