Skip to main content
A
agracia1-Visitor
1-Visitor
June 11, 2019
Solved

Loft between circles to create a reducing elbow

  • June 11, 2019
  • 2 replies
  • 6579 views

Hello! I am trying to create a model of a reducing elbow (4 to 3). I have the straight ends of the elbow and I was hoping I could loft between the parts.  I followed the instructions per the PTC help, but when I try to create Matchlines, I get an error that says "The profile must be closed." So I can only assume that I am picking the wrong vertex? I cannot attach the pkg file I am working with, but I can send it to someone that thinks they can help. Can someone please help me? Maybe lofting is not the way to go, but it was the only method that I thought made sense! Thanks!

Best answer by GaryLinscheid

Lofting would be correct. Can you attach a picture of the workplanes or send the pkg file?  2D profiles on each workplane must be closed and have the same number of vertexes.

2 replies

B
BHOoi16-Pearl
16-Pearl
June 12, 2019

If I understood your issue correctly, this is what you wanted to do.

 

Attached is Creo4 file.blend.jpg

A
agracia1-VisitorAuthor
1-Visitor
June 12, 2019

Yes, that is pretty much what I want to do.  Is that in parametric? what commands did you used? I am in E/DM, some of the modeling commands are similar. Below is what I am trying to make. It is an off the shelf part that I can't find a model of anywhere.

S
23-Emerald III
StephenW23-Emerald III
23-Emerald III
June 12, 2019

This board is specifically for Creo Parametric.

I will move this question to Creo Elements Direct board so you can get the right help.

https://community.ptc.com/t5/Creo-Elements-Direct-Modeling/bd-p/creo_elementsdirect

G
GaryLinscheid15-MoonstoneAnswer
15-Moonstone
June 12, 2019

Lofting would be correct. Can you attach a picture of the workplanes or send the pkg file?  2D profiles on each workplane must be closed and have the same number of vertexes.

A
agracia1-VisitorAuthor
1-Visitor
June 12, 2019

Here is a package file.

G
GaryLinscheid15-Moonstone
15-Moonstone
June 12, 2019

I have attached a modified pkg file.

 

You need to use the split 2D command on each circle to create a vertex on each circle on all workplanes. Also remove the real 2D line on each workplane.

 

You will need additional workplanes to control the loft in between the two end planes.

Terms & ConditionsCookie settingsAccessibility statement