Creo 7.0-10.0 + Windows 10 Bootcamp + MacBook Pro : Extremely Slow Spin Wheel

[shrewdgeartrain]

Previously, I had Creo 7.0 installed on a Bootcamp partition of Windows 10. It ran perfectly with no issues in viewing a large assembly of parts or single parts. Recently, I readjusted the bootcamp partition size to be smaller, reinstalled Windows 10, and all associated software I previously had. 

Now, I have tried installing Creo 7.0-10.0, all with the same resulting issue, I cannot even spin a basic one-part model without the Microsoft spin wheel slowing me down.

I have read this may be a graphics card issue. Current card is Intel UHD Graphics 630 1536 MB, however, I did not have issues with this before.

Looking for any help troubleshooting this.

[MartinHanak]

Hi,

in Windows 10 install 27.20.100.9466 Intel UHD Graphics driver and disable driver automatic update.

[shrewdgeartrain]

Martin,

I have been actually having a hard time finding 27.20.100.9466 on Intel's website. I don't trust downloading it from anywhere else. If you have a link, that would be greatly appreciated.

[MartinHanak]

---

@shrewdgeartrain wrote:

Martin,

I have been actually having a hard time finding 27.20.100.9466 on Intel's website. I don't trust downloading it from anywhere else. If you have a link, that would be greatly appreciated.

---

Hi,

if you trust Dell then you can download Intel-UHD-Graphics-Driver_WW8K2_WIN_27.20.100.9466_A04_01.EXE from https://www.dell.com/support/home/cs-cz/drivers/driversdetails?driverid=ww8k2 page and test it. Maybe it resolves your problem.