save a copy assembly window issue? creo 2.0

[rohit_rajan]

has the issue with "save a copy" assembly window resolved in creo 2.0 M030?

[TimBrotherhood]

What specifically was the problem you had with Save As for assemblies?

[rohit_rajan]

finally someone asked? I have posted a video also on the issue? i will upload the video here also... Video Link : 3785

As you can see in the video the "save copy " window does not come up properly..then when i try to move to move the window to see the other options in does not move....how will i be able to save copy in this way???????????????

[TimBrotherhood]

I searched and I think found your original video. http://communities.ptc.com/message/198051#198051

From the video it looks like the vertical resolution of your screen is too low to display the full height of the dialog. The minimum spec for Creo 2 is 1280 x 1024. We have the same problem in high schools who have low spec screens.

[rohit_rajan]

thanx for your reply...

well then that is a big problem? Pro|Engineer Wildfire 5.0 was independent of this .......no issues there...the window should still be scalable?........i don't think to be able to use save s copy..i need to replace all my monitors?...i think this is some kind of bug....the window is not scalable diagonally also.....

[AdamHaas]

As Tim mentioned above, the minimum monitor resolution for Creo is 1280x1024 and unless someone on the forums has a clever solution I have not thought about, you will not be able to use the Save a Copy functionallity.

I was able to duplicate your issue by setting my resolution to 1280x800 and as expected, I was not able to use the Save a Copy functionallity for assemblies.

Regards,

Adam

[rohit_rajan]

why do i not face this issue in any other window in Creo 2.0?.....