cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

We could not post an idea

DunamisMachines
13-Aquamarine

We could not post an idea

Suggest an idea is greyed out. How to post idea? We have logged in but still We can not suggest an idea. We need a pattern which will be on curve equally displaced.

1 ACCEPTED SOLUTION

Accepted Solutions

  • @DunamisMachines 
    Thankyou for using PTC Community!
    Please try posting an idea using Submit an idea link available under the respective product discussion board. For example for Creo its to be submitted here.
    Same way for other products(ex. Windchill), select Windchill from the home page 
     vnamboodheri_0-1626677793341.png
  • Then Click on Windchill Ideas as shown below  
    vnamboodheri_1-1626677967404.png
  • Then Click on Submit an Idea as shown below
    vnamboodheri_2-1626678248576.png

     

Hope this helps.

Best Regards,
vnamboodheri

View solution in original post

2 REPLIES 2

  • @DunamisMachines 
    Thankyou for using PTC Community!
    Please try posting an idea using Submit an idea link available under the respective product discussion board. For example for Creo its to be submitted here.
    Same way for other products(ex. Windchill), select Windchill from the home page 
     vnamboodheri_0-1626677793341.png
  • Then Click on Windchill Ideas as shown below  
    vnamboodheri_1-1626677967404.png
  • Then Click on Submit an Idea as shown below
    vnamboodheri_2-1626678248576.png

     

Hope this helps.

Best Regards,
vnamboodheri

Thank you so much. It worked.

Announcements