cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Need to share some code when posting a question or reply? Make sure to use the "Insert code sample" menu option. Learn more! X

Assembly from Creo 9 is not opening in Creo 7.0 or 8.0

AZ_10269788
2-Explorer

Assembly from Creo 9 is not opening in Creo 7.0 or 8.0

I am using Creo Parametric Release 9.0 and Datecode9.0.2.0

i updated Creo parametric to 9.0.2 and i found an issue that my collegue with version 8.0 and 7.0 are not able to open the assembly

ACCEPTED SOLUTION

Accepted Solutions
tbraxton
22-Sapphire I
(To:AZ_10269788)

If you save a model using Creo 9, that file will not open in an earlier release.

 

  • Pro/ENGINEER, Creo Elements/Pro and Creo Parametric support upward compatibility
    • Data created in an older release can open in a newer release
    • Higher version data cannot open in lower version of application.

 

See this article:

Article - CS34192 - Data compatibility between all releases of Pro/ENGINEER, Creo Elements/Pro and Creo Parametric (ptc.com)

========================================
Involute Development, LLC
Consulting Engineers
Specialists in Creo Parametric

View solution in original post

1 REPLY 1
tbraxton
22-Sapphire I
(To:AZ_10269788)

If you save a model using Creo 9, that file will not open in an earlier release.

 

  • Pro/ENGINEER, Creo Elements/Pro and Creo Parametric support upward compatibility
    • Data created in an older release can open in a newer release
    • Higher version data cannot open in lower version of application.

 

See this article:

Article - CS34192 - Data compatibility between all releases of Pro/ENGINEER, Creo Elements/Pro and Creo Parametric (ptc.com)

========================================
Involute Development, LLC
Consulting Engineers
Specialists in Creo Parametric
Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags