Skip to main content
D
Dawek1-Visitor
1-Visitor
February 20, 2020
Solved

Creo 4 Failed to connect to server

  • February 20, 2020
  • 1 reply
  • 10067 views

Hello, 

I have recently installed Creo 4(M80) and it fails to run with error (-96) Failed to connect to server. Server is down or unreachable.

The thing is that i am at home connected via VPN to the network where licencing server is running. However when i brought my PC with me and physically connected my to the network, everything ran just fine.

I tried running it with firewall disabled on my PC as well as on the licensing server, but i keep getting the (-96) message. 

Any suggestions what to try next?

 

P.S. Don't mind the (-21) message

Best answer by MartinHanak

cs273568.png

Try the above mentioned advice.

1 reply

M
Mahesh_Sharma22-Sapphire I
22-Sapphire I
February 20, 2020

@Dawek

 

As this is due to communication, check connectivity on port 7788 and also check for any other firewall blockages in vpn.

 

CS21768

D
Dawek1-VisitorAuthor
1-Visitor
February 20, 2020

I tried to use telnet to check the port connectivity. I typed: telnet xxx.xxx.xxx.xxx 7788 (xxx for the server IP) and the command line turned complete black with just a cursor blinking in top left corner. That means the port is open, right?

M
MartinHanak24-Ruby III
24-Ruby III
February 21, 2020

Hi,

what value did you set ... IP address -or- fqdn ?

Terms & ConditionsCookie settingsAccessibility statement