1-Visitor

Solved

How to do a section in an axonometry wiew in drawing?

Forum|Forum|10 years ago
October 9, 2015
1 reply
3894 views

Hi

I have to do an axonometry wiew but with a section! And if is possible in shading with edge rappresentation as in the picture below!

I did this saving the jpeg file and putting it as object in drawing, is the only way to do it?

Thanks!

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

General

Best answer by MartinHanak

Luca,

you can use following procedure:

1.] add x-hatching default real number parameters into your model (Tools > Parameters)

default_xhatch_angle

default_xhatch_spacing

See details in http://help.ptc.com/creo_hc/creo30_pma_hc/usascii/index.html#page/pma/fundamentals/fund_four_sub/To_Set_the_Default_Spac…

These parameters drive x-hatching properties displayed on the drawing.

2.] create Zone (3D x-section) in your mode ... see myzone in my model (created in CR2 M070)

3.] in drawing view properties in Sections category set 3D cross-section myzone

You cannot modify x-hatching of 3D x-section in Drawing mode!!!

MH

Answer

24-Ruby III

Luca,

you can use following procedure:

1.] add x-hatching default real number parameters into your model (Tools > Parameters)

default_xhatch_angle

default_xhatch_spacing

See details in http://help.ptc.com/creo_hc/creo30_pma_hc/usascii/index.html#page/pma/fundamentals/fund_four_sub/To_Set_the_Default_Spac…

These parameters drive x-hatching properties displayed on the drawing.

2.] create Zone (3D x-section) in your mode ... see myzone in my model (created in CR2 M070)

3.] in drawing view properties in Sections category set 3D cross-section myzone

You cannot modify x-hatching of 3D x-section in Drawing mode!!!

MH

Author

1-Visitor

It works thanks!!

I have a little question more!

I have to do it in an assembly, is possible to exclude any components? an example screws, nuts exc...

Thanks!

Author

1-Visitor

I understand the procedure, but maybe i made a mistake on the question formulation!!

The meaning was that i want to exclude some parts from the section hatch and continue to see these un-cutted!!

Some parts have to be sectioned an some no.

It's possible do this?

Sorry for the mistake; Thanks!!